1.75 mm GreenTec Pro Carbon filament with carbon fibers, BlackExtrudr
A biodegradable material made from sustainable resources loaded with the strength of high-performance carbon fibers. Lightweight, resistant to high temperatures and stiff.
|Buy - Prices VAT included|
Biodegradable filament with 10% carbon fibers, black color.
Carbon is very abrasive. Therefore we recommend a hardened nozzle and a minimum nozzle diameter of 0.5mm!
- High durability
- Hard and stiff
- Lightweight 10% lighter than PLA and PETG
- 100% compostable
- Very good mechanical properties
- Chemical resistant to many agents (view data sheet)
- High impact resistant
- UV resistant like ASA
- Ideal for complex design
- Matte surface
- REACH & Rohs compliant
|Nominal diameter||1.75 mm|
|Printing temperature||200-240 °C|
|Heat Deflection Temperature||up to 115 °C|
To obtain the best layer adhesion use a printing temperature of about 230-240 °C. The material is printable from about 200 °C but the layer adhesion suffers significantly. Set the heated bed from 0 to 90 °C. Suggested printing speed: 60-180 mm/s.
Motorsports, aerospace, medical devices, prostheses industry.
Carbon is very abrasive. Therefore it is recommend a hardened nozzle. The carbon fiber stabilizes the material and therefore reduces the distortion and stabilizes the plastic snarl during bridging.
Store at room temperature 18-27 °C in a dry place. Make sure it is out of direct heat and sunlight.
Due to all the different types of hot-end it's extremely difficult to give a temperature advice. Please consider our tips as a starting point to find the temperatures that work well in your setup. You may have to adjust the temperature settings slightly based on your type of printer.