1.75 mm PLA NX2 filament Matt finish, AnthraciteExtrudr
NX2 is a bio compound, compostable, non-toxic, based on natural and renewable resources. Matt finish, mechanical properties and high definition results. → Anthracite
|Buy - Prices VAT included|
Plastic filament out of PLA in anthracite.
- Matt finish!
- Low shrinkage, less than 0.5%
- High speed, up to 120mm/s
- High definition
- High impact resistance
- Easy to print
- FDA approved
|Nominal diameter||1.75 mm|
|Printing temperature||~ 195-220 °C|
|Melting temperature||~ 150 °C|
PLA NX2 filament is a biopolymer made of 100% renewable resources containg sugar and starch. Print it on blue tape, no heated bed required.
Due to all the different types of hot-end it's extremely difficult to give a temperature advice. Please consider our tips as a starting point to find the temperatures that work well in your setup. You may have to adjust the temperature settings slightly based on your type of printer.