1.75 mm ABS filament, Opal Green
feelcolorABS is used for products that need impact resistance, heat resistance and a pleasant aesthetic finish. To print with ABS filament you need a well-ventilated room. → Opal Green
Buy - Prices VAT included |
---|
Plastic filament out of ABS in opal green.
Features
- High strength material
- Easy to print
- Softer than PLA
- Unpleasant odor during printing
Tech specifications
Nominal diameter | 1.75 mm |
Warp | high |
Flexibility | low |
Break resistance | high |
Printing temperature | ~ 195-225 °C |
Temperature resistance | up to ~ 97 °C |
Tips&Tricks
It is recommended to set your heated print bed temperature to approximately 70-80 °C.
A heated chamber, especially for big parts, is recommended. Print in a ventilated area to facilitate the exchange of air.
Due to all the different types of hot-end it's extremely difficult to give a temperature advice. Please consider our tips as a starting point to find the temperatures that work well in your setup. You may have to adjust the temperature settings slightly based on your type of printer.