2.85 mm ABS filament, Pure Red

feelcolor

ABS is used for products that need impact resistance, heat resistance and a pleasant aesthetic finish. To print with ABS filament you need a well-ventilated room. → Pure Red

Buy - Prices VAT included
Sample (2 meters) €1,00
5 meters €3,50
10 meters €6,00
10 meters on spool €7,00
20 meters on spool €11,00
30 meters on spool €16,50
Spool 1 kg €32,50

Plastic filament out of ABS in pure red.

Features

  • High strength material
  • Easy to print
  • Softer than PLA
  • Unpleasant odor during printing

Tech specifications

Nominal diameter 2.85 mm
Warp high
Flexibility low
Break resistance high
Printing temperature ~ 195-225 °C
Temperature resistance up to ~ 97 °C

Tips&Tricks

It is recommended to set your heated print bed temperature to approximately 70-80 °C.
A heated chamber, especially for big parts, is recommended. Print in a ventilated area to facilitate the exchange of air.

Due to all the different types of hot-end it's extremely difficult to give a temperature advice. Please consider our tips as a starting point to find the temperatures that work well in your setup. You may have to adjust the temperature settings slightly based on your type of printer.


Datasheet