ATTENZIONE! Gli ordini sono sospesi fino a nuove disposizioni del Governo Italiano.
Per ordinare materiali funzionali a fronteggiare l'emergenza contattaci via email a [email protected]
WARNING! Orders are suspended by regulations of the Italian Government.

1.75 mm PETG filament, White

FiloAlfa

PETG features high impact and chemical resistance, excellent hardness and low retraction. It has a brilliant and glossy finish and it's easy to print.

Buy - Prices VAT included
Sample (4 meters)	€1,50
10 meters	€3,80
15 meters	€4,80
30 meters on spool	€10,00
45 meters on spool	€15,00
60 meters on spool	€19,50
Spool 700 g	€34,00

FiloAlfa

Tech sheet

Filament out of PETG in white.

Features

Easy to print
Glossy finish
High strength and rigidity
High dimensional stability
Food contact safe
Low-odor during printing

Tech specifications

Nominal diameter	1.75 mm
Warp	very low
Flexibility	low
Break resistance	medium
Printing temperature	~ 210-230 °C
Temperature resistance	up to ~ 72 °C

Tips&Tricks

PETG prints at slightly higher temperature than PLA. If heated bed available, set it at about 0-70 °C.
Suggested print speed: 40-60 mm/s.

Due to all the different types of hot-end it's extremely difficult to give a temperature advice. Please consider these tips, provided by the manufacturer, as a starting point to find the temperatures that work well in your setup. You may have to adjust the temperature settings slightly based on your type of printer.

Datasheet