1.75 mm MagicFil™ Thermo PLA, Grey to Transparent

A revolutionary colour changing PLA filament. This MagicFil™ Thermo PLA filament has an opaque grey colour below 30° C, however, when the material reaches a temperature of 30° C, or above, it will change into a transparent colour!

Buy - Prices VAT included
Sample (4 meters) €4,00 €3,00
10 meters €9,80 €7,80


Below 30° C the PLA filament is grey, above 30° C the filament changes to transparent.


  • Colour changing grey to transparent
  • Reversible changing colour
  • Much less warp than ABS
  • Easy to print
  • Heated bed not required

Tech specifications

Nominal diameter 1.75 mm
Warp mid
Flexibility low
Break resistance mid
Printing temperature 200-220 °C
Glass transition temperature ~ 60 °C


If you print with heated bed it is recommended to set the bed temperature to approximately 40-50 °C.

Due to all the different types of hot-end it's extremely difficult to give a temperature advice. Please consider our tips as a starting point to find the temperatures that work well in your setup. You may have to adjust the temperature settings slightly based on your type of printer.