2.85 mm MoldLay wax-like filament, Blue
Lay FilamentsA revolutinary 3D material. You can perfectly print a mould for permanent casting and for lost-wax casting. MoldLay is stiff and rigid at room temperature and gets very liquid when heated up to ~ 270°C so the molten wax alike material can flow out.
Buy - Prices VAT included |
---|
Video
Wax-like filament in blue.
Experimental filament.
For experienced user.
Features
- Almost no warp
- Low viscosity at high temperature
- High dimensional stability
- Solid and keeps its shape
- No heated bed required
- Food contact safe
- Liquefies at ~ 270 °C (emptying the cast)
Tech specifications
Nominal diameter | 2.85 mm |
Warp | near zero |
Flexibility | n.a. |
Break resistance | n.a. |
Printing temperature | ~ 170-185 °C |
Temperature resistance | n.a. |
Tips&Tricks
Heated bed not required, if available set it at max. 40 °C.
TIP!
MoldLay is best stored dry. If the material absorbed moisture after some time, the filament can be dryed in an oven at max. 40 °C for four to five hours.
TIP!
Before removing the object from the bed cool down and wait 20 minutes.
Due to all the different types of hot-end it's extremely difficult to give a temperature advice. Please consider these tips, provided by the manufacturer, as a starting point to find the temperatures that work well in your setup. You may have to adjust the temperature settings slightly based on your type of printer.