1.75 mm Armadillo semi rigid filament, Snow WhiteNinjaTek
Armadillo™ is a high performing rigid material, providing 90% higher abrasion resistance than nylon. Its resistance to fracturing makes it a perfect filament when you need a rigid product that can withstand wear and tear. → White
|Buy - Prices VAT included|
TPU filament in white.
- Shore Hardness 75D
- Toughness: 86 times greater than ABS
- High abrasion resistance: 84% better than PLA and 60% better than ABS
- Chemical resistance to many materials (naphtha, ASTM Oils #1-3, petroleum and freon)
- Excellent bridging capabilities
- No warping issues
- Heated bed not required
|Nominal diameter||1.75 mm|
|Break resistance||very high|
|Printing temperature||~ 220-230 °C|
|Glass Transition Temperature||-10 °C|
Heated bed not required, if available set it between 0-45 °C. Glue or blue tape is suggested if not using a heated bed. Suggested print speed: for top and bottom layers around 15-20 mm/s, for infill around 45-60 mm/s. If available use cooling fan after the second layer.
Braces, fasteners, gears and protective covers.
When switching from another polymer (such as ABS or PLA) purge thoroughly before starting a print. As with other materials, when preheating, use a lower temperature (~180-200°C) to prevent excess material from draining prior to starting a print.
Due to all the different types of hot-end it's extremely difficult to give a temperature advice. Please consider our tips as a starting point to find the temperatures that work well in your setup. You may have to adjust the temperature settings slightly based on your type of printer.