3 mm smartABS filament, Natural


smartABS is a hard and tough material. With smartABS you get 90% less junk. The bond between the layers is much better, because smartABS has much less warp than usual ABS (heated bed off, fan on). Nice to print between 235 °C and 245 °C.

Buy - Prices VAT included
Sample (2 meters) €1,00 €0,50
5 meters €3,50 €1,75

Natural plastic filament out of smartABS.


  • Hard material
  • Very good inter-layer adhesion
  • Less cracks between layers than usual ABS
  • Much less warp than usual ABS
  • Optimized for printers without heated bed

Tech specifications

Nominal diameter 3 mm
Warp mid
Flexibility mid
Break resistance high
Printing temperature ~ 245 °C
Temperature resistance up to ~ 100 °C


If foam comes out of the nozzle, the material has to be dried at ~ 75 °C for two hours.

Due to all the different types of hot-end it's extremely difficult to give a temperature advice. Please consider our tips as a starting point to find the temperatures that work well in your setup. You may have to adjust the temperature settings slightly based on your type of printer.