1.75 mm HTPLA filament, Glitter StardustProto-pasta
An easy-to-print Glitter! Another wonderful HTPLA filament by Proto-Pasta. If you want to make a print more fun, just add glitter. No abrasive fillers so expect normal wear with standard nozzles.
|Buy - Prices VAT included|
HTPLA filament with glitter inside.
Glitter Flake has little risk of clogging, so be sure to clean your nozzle after printing with glitter. Glitter particles will lay flat with smaller layers, giving top/bottom surfaces more shine than sidewall, so have some fun playing with resolution to see how the result changes.
- Easy to print
- No heated bed required
- Usable on most PLA-compatible printers
|Nominal diameter||1.75 mm|
|Printing temperature||190-230 °C|
|Temperature resistance||88-110 °C, 140 °C if treated|
Good results were achieved using standard PLA parameters with standard build surface preparation (blue tape, glue stick, or BuildTak). No heated bed required but up to 70 °C is okay.
How to do "Heat Treatment"
Bake your parts into a oven until you see a change from translucent to opaque. There is an obvious visual change indicating the improved performance! Good results were achieved in a lab oven at 110 °C for an hour or less. We recommend leaving the supports on your parts, placing them on a non-radiating surface (like glass, ceramic, or composite), and letting them cool in the oven to minimize distortion. Parts can be baked at a lower temperature (though must be above 60 °C for any change to occur) for a longer time with less risk of unwanted deformation.
When you anneal a material like PLA materials it means that the plastic will continue to harden when exposed to low but consistent heat. Annealing will cause any 3d printed objects to temper, making it significantly less brittle and extremely tough. If done correctly, annealed parts will be resistant to warping, and maintain its original shape and structure.
However it may slightly shrink, so any critically-sized prints may be scaled up slightly by about 2 to 2.5% to make sure it will still fit any adjoining parts.
Due to all the different types of hot-end it's extremely difficult to give a temperature advice. Please consider these tips, provided by the manufacturer, as a starting point to find the temperatures that work well in your setup. You may have to adjust the temperature settings slightly based on your type of printer.